① Scratch transfer on the sliding surface of the piston Before the piston is installed, there are scratches on the sliding surface, which are not treated and installed intact. These scratches will in turn scratch the inner surface of the cylinder wall. Therefore, these scars must be fully trimmed before installation.
② The sintering phenomenon caused by the excessive pressure on the sliding surface of the piston will cause the piston to tilt due to the self-weight of the piston rod, resulting in a different phenomenon, or the pressure on the sliding surface of the piston will rise due to the action of lateral load, which will cause the sintering phenomenon. When designing the hydraulic cylinder, its working conditions must be studied, and sufficient attention must be paid to the length and clearance of the piston and bushing.
③ Peeling of the hard chrome plating on the inner surface of the cylinder It is generally believed that the reasons for the peeling of the hard chrome plating are as follows.
а. Шар покриття погано зчеплений. Основними причинами поганої адгезії гальванічного шару є: перед нанесенням гальванічного покриття недостатньо знежирення та знежирення деталей; поверхнева активаційна обробка деталей не є ретельною, а шар оксидної плівки не видаляється.
б. Жорстка підкладка зношена. Зношування гальванічного шару твердого хрому здебільшого викликано шліфуванням фрикційного залізного порошку поршня. Коли в середині є волога, зношування відбувається швидше. Корозія, викликана контактною різницею потенціалів металу, виникає тільки в тій частині, де стикається поршень, і корозія відбувається у вигляді точок. Як і вище, наявність вологи в середині сприятиме розвитку корозії. У порівнянні з виливками контактна різниця потенціалів у мідних сплавів вища, тому ступінь корозії мідних сплавів є більш серйозною.
c. Корозія через контактну різницю потенціалів. Контактна різниця потенціалів корозія нелегко виникає для гідроциліндрів, які працюють протягом тривалого часу; це поширена несправність гідроциліндрів, які тривалий час не використовуються.
④ Damage to the piston ring The piston ring is damaged during operation, and its fragments are caught in the sliding part of the piston, causing scratches.
⑤ The material of the sliding part of the piston is sintered and cast piston, which will cause sintering phenomenon when it bears a large lateral load. In this case, the sliding part of the piston should be made of copper alloy or welded with such material.










